Inserting The Roll Paper - Konica Minolta CR-400 Instruction Manual

If the data processor is left for a long period with the power switch turned OFF, electricity is
discharged from the memory backup battery, disabling data backup. In this case, data stored
in the memory will be corrupted. If the data processor is started in this condition, the data
processor initializes all data stored in the memory. In addition to all items described in "Initial
Setting" on P.76, the following items will be initialized.
1) Date/time will be initialized to "2002/01/01 00:00".
2) The language setting will be initialized to "ENGLISH".

Inserting the Roll Paper

Measuring Head
See P.27 "Turning the Power ON and OFF" for details on the measuring head.
The data processor has a thermal printer which does not require an ink ribbon. Printed data may
become difficult to read because of the way the paper has been stored. Use new roll paper whenever
possible. Also, it is recommended to copy data intended for long-term storage immediately after it has
been printed.
Notes on Use
[Operating Procedure]
1 Press the button to unlock the paper
compartment, then flip the cover open.
Load the paper roll so that the underside of
2 Load the roll paper so that it is oriented
the paper faces upward.
as shown in the illustration, and pull the
paper out so that about 3 - 4 cm of it
extends over the paper cutter.
Lock release button
Paper compartment cover
Printhead
Roll paper
67