Connecting The Ac Adapter - Konica Minolta CR-400 Instruction Manual

Connecting the AC Adapter

Using the instrument continuously for long periods of time or transferring data using the RS-232C
terminal consumes a lot of electricity, so we recommend you use the AC adapter (AC-A305).
Always use the AC adapter supplied as a standard accessory or the optional AC adapter, and
connect it to an AC outlet of the rated voltage and frequency. If the AC adapters other than
those specified by KONICA MINOLTA are used, this may result in damage to the unit, fire or
electric shock.
If the instrument will not be used for a long time, disconnect the AC adapter from the AC
outlet. Accumulated dirt or water on the prongs of the AC adapter's plug may cause a fire and
WARNING
should be removed.
Do not disassemble or modify the instrument or the AC adapter. Doing so may cause a fire or
electric shock.
The instrument should not be operated if it is damaged, or AC adapter is damaged or if smoke
or odd smells occur. Doing so may result in a fire. In such situations, turn the power OFF
immediately, disconnect the AC adapter from the AC outlet (or remove the batteries if they
are used) and contact the nearest Konica Minolta authorized service facility.
Do not connect or disconnect the AC adapter with wet hands. Doing so may cause electric
shock.
When using an AC adapter, make sure that the AC outlet is located near the instrument and
that the AC adapter can be connected to and disconnected from the AC outlet easily.
CAUTION
25