Konica Minolta CR-400 Instruction Manual page 53

• The menu screen will appears.
3 Press the Enter key
Start-up screen
Move the cursor using the
4
• The PC mode screen appears.
• Pressing the Escape key returns to the measurement screen.
When removing the RS-232C cable, turn OFF
the measuring head and data processor and push
Press the Enter key
5
the lock release button certainly while removing
the cable.
If the lock is not released and remove it by force,
the connector may be damaged.
If you connect the measuring head to the data
processor with the measuring head power switch
turned ON when you have returned to the mea-
surement screen with the Escape key after PC
mode operation with the measuring head, a mea-
surement error may occur, resulting in a con-
nection failure. In this case, turn OFF the mea-
suring head power switch, and then re-connect
the measuring head to the data processor.
while in the start-up screen.
key and select "PC MODE."
.
Menu screen
Lock release
button
Menu screen
PC mode
menu screen
51