Connecting To External Devices; Connecting The Pc - Konica Minolta CR-400 Instruction Manual

Connecting to External Devices

Data can be transferred between the instrument and a PC by connecting the instrument's RS-232C
terminal to a PC.
We recommend using the AC adapter (AC-A305) when connected to a PC because of the higher power
consumption involved.
<Connecting the PC>
By connecting the instrument to a PC/AT compatible PC using the
verter cable or RS-232C
Use the optional CR-400 utility software CR-S4w and the Color data software
CM-S100w when connecting the instrument to a PC.
The followings can be used in PC mode:
1. Outputting measurement and target color data to a PC
2. Reading target color data from a PC.
3. Changing Settings
4. Registering a User Index
See P.50 "Changing to PC Mode" for details.
• When connecting, make sure that the connectors are correctly oriented and fastened securely with
screws.
• Before connecting, make sure that the power to both the instrument and PC is turned OFF.
• Hold the connector when connecting or disconnecting. Do not bend, pull, or apply undue pressure
to the cord, as this may cause it to break.
• Do not touch the connector terminals with your hand. Doing so may cause them to get dirty or
subject them to excessive force.
Notes on Use
• Make sure that the cable is long enough. Tensing the cable may cause connection failure or wire
breakage.
• If optional RS-232C cable CR-A102 is not used, make sure the cable specifications match the pin
number/signal connection diagram for an RS-232C cable below. An inappropriate cable will pre-
vent data from being input and output properly and may cause malfunctions.
• Communication Parameters
Item
Baud rate
Charactor length
Parity
Stop bit
• RS-232C cable pin number/signal connection diagram
cable, the data stored in the instrument memory can be transfer each other.
4800bps
optional accessory USB-serial con-
SpectraMagic™
Setting
9600bps 19200bps
8bit
None
1bit
NX
49