Table of Contents
Advertisement
Handling the Instrument
Inserting Batteries
This instrument can be powered by four AA batteries (alkaline batteries or nickel-metal hydride rechargeable batteries). Use batteries as needed for the application.
Notes
• Do not use manganese batteries.
• Remove the batteries if the instrument will not be used for at least 2 weeks. If the batteries are left in the instrument for long periods, the batteries may leak and
damage the instrument.
• Do not mix battery types or use a mixture of new batteries and used batteries. Doing so may cause the batteries to rupture or a decrease in battery life.
• Do not touch or short-circuit the terminals in the battery compartment. Doing so may damage the instrument.
Procedure
❶
Verify that the power has been turned
OFF (LCD screen display is blank).
❷
To open the battery compartment
cover, slide the cover in the direction
indicated by the arrow.
❸
Insert four AA batteries according to
the polarity indications shown in the
battery compartment.
(Cont.)
❹
To close the cover, insert the
protrusions on the cover in to the
holes on the battery compartment on
the instrument, and then press the
cover in until it clicks.
Powering from a PC
The included USB cable (IF-A25) can be used to connect the instrument to and power the
instrument from a PC. Refer to "Connecting to a PC" on page 37 for details on
connecting the instrument to a PC.
Notes
When unplugging the USB cable from the instrument or the PC, be sure to
verify that the instrument power has been turned OFF.
13
Advertisement
Table of Contents
