Intended Use - Festo CPX-CM-HPP Description

Contents and general instructions

Intended use

Festo CPX-CM-HPP-EN 2017-06b English
The module CPX-CM-HPP documented in this description is
intended exclusively for use in CPX terminals from Festo for
installation in a machine or automated system.
The CPX-CM-HPP in combination with a controller allows the
independent actuation of up to four drives via CAN bus.
The CPX terminal with the CPX-CM-HPP must only be used as
follows:
– As intended in an industry segment.
– in its original state without unauthorised modifications.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
– in perfect technical condition.
– only in combination with approved components For an
overview of supported motor controllers, refer to
Tab. 1/4.
The limit values specified for pressures, temperatures,
electrical data, torques etc. must be observed.
Observe the regulations of the trade associations, German
Technical Control Board (TÜV), VDE stipulations or
corresponding national laws and regulations.
VII