Applicable documents
1
Applicable documents
All available documents for the product è www.festo.com/pk.
1.1
Specified standards
Standard
EN ISO 13849-1:2008-06
EN ISO 13849-2:2008-06
EN 50295:1999-10
EN 60204-1:2006-06
EN 61508-3:2010-05
IEC 62026-2:2008-01
EN ISO 4414:2010-11
Tab. 1 Standards
2
Safety
2.1
Safety instructions
–
Only use the product in original status without unauthorised modifications.
–
Only use the product if it is in perfect technical condition.
–
Observe labelling on the product.
–
Take into consideration the ambient conditions at the location of use.
–
Prior to mounting, installation and maintenance work: Switch off power supply and secure it from
being switched back on.
–
Observe tightening torques. Unless otherwise specified, the tolerance is ± 20 %.
2.2
Intended use
The product is intended solely for fast and safe venting and for building up pressure gently in pneu-
matic piping systems and terminals in industry.
4
Title
Safety of machinery - Safety-related parts of control systems
Part 1: General principles for design
Safety of machinery - Safety-related parts of control systems
Part 2: Validation
Low-voltage switching devices, control and device interface; Actuator
Sensor Interface (AS-interface)
Safety of machinery - Electrical equipment of machines
Part 1: General requirements
Functional safety of safety-related electrical/electronic/programmable
electronic systems
Part 3: Software requirements
Low-voltage switching devices - control device networks (CDIs)
Part 2: Actuator Sensor Interface (AS-i)
Fluid engineering - General rules and safety requirements for pneumat-
ic systems and their components
Festo — MS6(N)-SV-...-E-ASIS — 2019-05a