Terminating Resistor - Festo CPX-CM-HPP Description

2. Fitting and installation

2.4.2 Terminating resistor

2-8
A terminating resistor for the CAN bus is integrated at the
axis connection.
A can bus terminating resistor for 120 ohms must only be
installed at the other end of the CAN bus. Depending on the
actuator, this terminating resistor is integrated in the
actuator and activated with the DIL switch. If the actuator
does not have an integrated terminating resistor, it must be
connected manually between the signal CAN H (High) and
CAN L (Low).
Festo CPX-CM-HPP-EN 2017-06b English