Quantum DXi4500 Manual page 86

Dxi series command line interface (cli) guide
Hide thumbs Also See for DXi4500:
Table of Contents

Advertisement

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
86
1 Display the output of the current runtime network values using syscli -show
netcfg to list the current runtime values. (Runtime values are those values
that are currently used by the network service. Values must first be
configured using the add and delete netcfg commands. In order for these
values to become runtime values, the system must be rebooted. This will
restart the network service. You can use the syscli --nodemanage -reboot
command to reboot the system after all network configuration has been
done.)
Note: The WARNING: No Replication IP configured message at the
bottom means that an interface was not configured specifically for
replication. An interface can be configured for replication using the
--policy REP option in the syscli --add netcfg command if desired.
[root@rok‐dxi92 DXi]# syscli ‐‐show netcfg
bond0     Link encap:Ethernet  HWaddr 00:50:56:AB:00:48
          UP BROADCAST RUNNING MASTER MULTICAST  MTU:1500  Metric:1
          RX packets:557471 errors:155 dropped:0 overruns:0 frame:0
          TX packets:48114 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:48747984 (46.4 MiB)  TX bytes:6195223 (5.9 MiB)
bond0:2   Link encap:Ethernet  HWaddr 00:50:56:AB:00:48
          inet addr:10.20.185.92  Bcast:10.20.191.255  
Mask:255.255.248.0
          UP BROADCAST RUNNING MASTER MULTICAST  MTU:1500  Metric:1
eth0      Link encap:Ethernet  HWaddr 00:50:56:AB:00:48
          UP BROADCAST RUNNING SLAVE MULTICAST  MTU:1500  Metric:1
          RX packets:278735 errors:5 dropped:0 overruns:0 frame:0
          TX packets:24057 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:24372519 (23.2 MiB)  TX bytes:3113468 (2.9 MiB)
          Interrupt:51 Base address:0x2080
eth1      Link encap:Ethernet  HWaddr 00:50:56:AB:00:48
          UP BROADCAST RUNNING SLAVE MULTICAST  MTU:1500  Metric:1
          RX packets:278736 errors:150 dropped:0 overruns:0 frame:0
          TX packets:24057 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:24375465 (23.2 MiB)  TX bytes:3081755 (2.9 MiB)
          Interrupt:67 Base address:0x20c0
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:5872300 errors:0 dropped:0 overruns:0 frame:0
          TX packets:5872300 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
Netcfg CLI Commands

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxi6500Dxi6700

Table of Contents