Figure 228 Add Trap Destination Page - Quantum DXi8500 User Manual

Figure 228 Add Trap
Destination Page
Quantum DXi8500 User's Guide
To add a destination:
1 Click Add.
The Add Trap Destination page displays (see
2 Enter information about the destination:
• IP Address - Enter the IP address of the system that will receive
the traps generated by the DXi8500.
Note: When entering IP addresses, never use an address that
is in a reserved IP address range. To see a list of
reserved IP address ranges, click the quick tip icon [?]
located near the IP address field.
Note: To use hostname format, you must specify at least one
DNS IP address on the Network page (see
page 366).
• Name - Enter the name of the destination.
3 Select one or more traps to send to the destination:
• Failure - Sends failure traps.
• Warning - Sends warning traps.
• Informational - Sends informational traps.
Chapter 9: DXi8500 Configuration
Notifications
Figure 228).
Network on
411