Displaying the
NetServer Status
Displaying the Last Run
Result of the Disk/
Network Analysis
Health Check CLI Commands
Starting a Health Check
Stopping a Health
Check
Scheduling a Health
Check
Health Check CLI Commands
syscli --getstatus netserver
This CLI command displays whether NetServer is enabled or disabled on the
system.
syscli --show throughput --disk | --network
This CLI command displays the last run result of the disk/network analysis.
The following sections describe the supported Health Check CLI commands:
•
Starting a Health Check
•
Stopping a Health Check
•
Scheduling a Health Check
•
Listing the Health Check Status
•
Editing the Health Check
•
Getting the General Status of System Health Checks
•
Getting the Health Check Schedule
syscli --start healthcheck
This CLI command allows the admin user to start a healthcheck on the system if
it is not running.
syscli --stop healthcheck
This CLI command allows the admin user to stop a healthcheck on the system if
it is running.
syscli --sched healthcheck --never | { --time <time> [--day
sun|mon|tue|wed|thu|fri|sat]}
This CLI command allows the admin user to schedule a healthcheck on the
system.
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
97