Quantum DXi4500 Manual page 258

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
258
Error Code Error Message
E8050081 CliListBonds: Failed to get /sys/class/net/bondX/bonding/
slaves file!
E8050082 CliListBonds: Failed to get /sys/class/net/bondX/bonding/
mode file!
E8050083 CliListBonds: Failed to get bond IP info!
E8050100 The netcfg script is not found!
E8050110 Netmask cannot be zero!
E8050111 Netmask is invalid, the rightmost bit must be zero!
E8050112 Netmask cannot contain non consecutive zero bits
E8050120 Network device name cannot be empty!
E8050121 Network device name is missing before comma!
E8050122 Network device name is missing after comma!
E8050123 Device name must start with an alphabetic label (valid format
is <label><devno>[:<vifno>])
E8050130 Device name: device number is missing (valid format is
<label><devno>[:<vifno>])
E8050131 Device name: device number is invalid
E8050132 Device name: device number is out of range
E8050133 Device name: device number has invalid trailing character!
E8050140 Device name: virtual interface number is missing (valid
format is <label><devno>[:<vifno>])
E8050141 Device name: virtual interface number is invalid
E8050142 Device name: virtual interface number is out of range!
E8050143 Device name: virtual interface number has invalid trailing
character!
E8050150 Command cannot run because custom configuration is
already in place!
E8050401 EnableJumbo: Option "enable" is missing.
E8050402 EnableJumbo: Option "enable" requires a value
E8050403 EnableJumbo: Option "enable" has invalid value
E8050404 EnableJumbo: Failed to read/get option "enable".
E8050405 EnableJumbo: Failed to write/set option "enable".
E8050411 EnableJumbo: Option "bond0" is required because another
optional option is specified!
CLI Error Codes