Quantum DXi4500 Manual page 87

Netcfg CLI Commands
RX bytes:564058955 (537.9 MiB) TX bytes:564058955 (537.9
MiB)
10.20.184.0/21 dev bond0 proto kernel scope link src 10.20.185.92
default via 10.20.184.1 dev bond0 src 10.20.185.92
0: from all lookup 255
32766: from all lookup main
32767: from all lookup default
WARNING: No Replication IP configured
Command completed successfully.
2 Delete bond0:
[root@rok‐dxi92 DXi]# syscli ‐‐del netcfg ‐‐devname bond0
You have specified the following data for command "DelNetcfg":
‐‐devname = bond0
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
Note: This will not change the output of syscli -show netcfg because the
add and delete netcfg commands only affect the network
configuration files and not the runtime values.
3 Add the eth0 and eth1 interfaces:
[root@rok‐dxi92 DXi]# syscli ‐‐add netcfg ‐‐devname eth0 ‐‐ipaddr
10.20.185.92 ‐‐netmask 255.255.248.0 ‐‐gateway 10.20.184.1
You have specified the following data for command "AddNetcfg":
‐‐devname = eth0
‐‐ipaddr = 10.20.185.92
‐‐netmask = 255.255.248.0
‐‐gateway = 10.20.184.1
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
[root@rok‐dxi92 DXi]# syscli ‐‐add netcfg ‐‐devname eth1 ‐‐ipaddr
10.20.185.117 ‐‐netmask 255.255.248.0 ‐‐gateway 10.20.184.1
You have specified the following data for command "AddNetcfg":
‐‐devname = eth1
‐‐ipaddr = 10.20.185.117
‐‐netmask = 255.255.248.0
‐‐gateway = 10.20.184.1
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
4 Reboot the system using the syscli --nodemanage -reboot command:
[root@rok‐dxi92 DXi]# syscli ‐‐nodemanage ‐‐reboot
You have specified the following data for command "Nodemanage":
‐‐reboot
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
87