Netcfg CLI Commands
32767: from all lookup default
WARNING: No Replication IP configured
Command completed successfully.
6 To create a bond using eth0 and eth1 as slaves, enter the following:
[root@rok‐dxi92 DXi]# syscli ‐‐add netcfg ‐‐devname bond0 ‐‐ipaddr
10.20.185.92 ‐‐netmask 255.255.252.0 ‐‐gateway 10.20.184.1 ‐‐slaves
eth0,eth1 ‐‐mode RR
You have specified the following data for command "AddNetcfg":
‐‐devname = bond0
‐‐ipaddr = 10.20.185.92
‐‐netmask = 255.255.252.0
‐‐gateway = 10.20.184.1
‐‐slaves = eth0,eth1
‐‐mode = RR
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
7 If you want to remove custom configuration such that the system is restored
with the network configuration values it was shipped with, use the syscli
-undo netcfg command. Remember to reboot the system for these values
to take affect.
[root@rok‐dxi92 DXi]# syscli ‐‐undo netcfg
Are you sure you want to proceed? [yes|no] > yes
Command completed successfully.
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
89