Quantum DXi4500 Manual page 82

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
Figure 2 Netcfg Example – Two
Ethernet Ports Only
82
The following syscli sequences can be used to configure a similar setup.
To display the existing configuration:
syscli --show netcfg
First, delete the default bond configuration with all customer ports connected
together:
syscli --del netcfg --devname bond0:2
Then configure Eth0 for IPADDR1 and for the replication source, if applicable,
configure GATEWAY1:
syscli --add netcfg --devname eth0 --ipaddr IPADDR1 --netmask NETMASK1 -
-gateway GATEWAY1 --policy REP
Then configure Eth0 for the other subnet. If applicable, configure GATEWAY2:
syscli --add netcfg --devname eth0 --ipaddr IPADDR2 --netmask NETMASK2 -
-gateway GATEWAY2
DXi 6540 With Three Bonds of Two Ports Each
The bonding mode would be inherited from the GUI basic page configuration,
and the different bonds can be in the same or a different subnet. Ensure that
the switch ports are appropriately aggregated and the gateways, if applicable,
are configured.
Netcfg CLI Commands