Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
88
Are you sure you want to proceed? [yes|no] > yes
Broadcast message from root (pts/1) (Wed Jun 8 09:51:50 2011):
The system is going down for reboot NOW!
Command completed successfully.
5 After the system comes back up, display the runtime network values using
syscli -show netcfg. They should now reflect the configured network
values. The output should now show eth0 and eth1 as independent
interfaces.
[root@rok‐dxi92 DXi]# syscli ‐‐show netcfg
eth0 Link encap:Ethernet HWaddr 00:50:56:AB:00:48
inet addr:10.20.185.92 Bcast:10.20.191.255
Mask:255.255.248.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:373 errors:0 dropped:0 overruns:0 frame:0
TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:32420 (31.6 KiB) TX bytes:9160 (8.9 KiB)
Interrupt:51 Base address:0x2080
eth1 Link encap:Ethernet HWaddr 00:50:56:AB:00:56
inet addr:10.20.185.117 Bcast:10.20.191.255
Mask:255.255.248.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:260 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:21262 (20.7 KiB) TX bytes:168 (168.0 b)
Interrupt:67 Base address:0x20c0
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2000 errors:0 dropped:0 overruns:0 frame:0
TX packets:2000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:177098 (172.9 KiB) TX bytes:177098 (172.9 KiB)
10.20.184.0/21 dev eth0 proto kernel scope link src 10.20.185.92
10.20.184.0/21 dev eth1 proto kernel scope link src 10.20.185.117
169.254.0.0/16 dev eth1 scope link
default via 10.20.184.1 dev eth0
0: from all lookup 255
32764: from 10.20.185.117 lookup eth1
32765: from 10.20.185.92 lookup eth0
32766: from all lookup main
Netcfg CLI Commands