Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
Creating Media
Listing the Media and
Attributes
22
[mediatype = 1]
type = SDLT1
capability = RW
[mediatype = 2]
type = SDLT2
capability = RW
[mediatype = 3]
type = DLTS4
capability = RW
syscli --add media --name <VTL_name> --type <media_type> --media
<number_of_media> --barcodestart <starting_barcode> --location slot |
ieslot [--capacity <media capacity>]
This CLI command allows the CLI admin to create a media for a defined VTL.
Creating a media is necessary after a VTL is created. The following are required
to create a media:
• VTL Name
• Media Type
• Number of media
• Starting barcode
• Initial location
The media type can be derived from the values returned from the type field
name of the list of media supported for a given tape drive model CLI. Initial
location can either be a slot or I/E slot.
The media capacity can optionally be specified. If media capacity is not
specified, it defaults to the media type native capacity.
syscli --list media --name <VTL_name> [--barcode <barcode>]
This CLI command allows the CLI admin to display a list of barcodes in the
system from the specified VTL name. When a barcode of the cartridge is
specified, this CLI returns the attributes of the single cartridge specified if it
exists. An example output of two media from VTL MyVTL is shown below.
List of media:
Total count = 2
[media = 1]
vtl = MyVTL
barcode = SDL101
-
type = SDLT
S4
VTL Configuration CLI Commands