Adding The Cli Directory To The Path - Quantum DXi4500 Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011

Adding the CLI Directory to the Path

CLI Help Commands
12
Finally, it should be noted that all options and values are defined as single
tokens in the command line syntax. Thus if a provided value consists of multiple
tokens, it must be quoted to prevent the shell from interpreting it as separate
tokens. For example:
syscli --add share .... --desc 'This is a test share'
In addition, if a provided value contains characters that are special to the shell,
these characters must be escaped correctly so that the shell treats them as
regular characters. For example,
syscli --add share .... --desc Testing\!
Note: The shell used in the CLI user accounts is the bash shell. The set of
special characters are the same characters that bash treats as special
characters. Refer to the bash shell documentation
www.gnu.org/software/bash/manual/bashref.html) for the set of
special characters interpreted by the shell. If you do not want the shell
to interpret any special characters, use single quotes (').
The syscli commands are located in the /hurricane directory. To make it easier to
invoke the CLI commands, you should add this path to the user profile.
To do this, add the following line to the user profile:
PATH=$PATH:/hurricane; export $PATH
The following help commands are available:
• Typing syscli alone will display a summary of help commands.
• Typing syscli help will show syntax for all syscli commands.
• Typing syscli help NAS | VTL | OST | REPLICATION |... will show syntax for
all Network Attached Storage (NAS), VTL, Open Storage Technology (OST),
replication, etc. commands respectively.
• Typing syscli help --<cmd> will show syntax for all commands named
<cmd>. For example, syscli help --list shows all list commands, syscli help
--add shows all --add commands.
• Typing syscli help --<cmd> <subcmd> will show detailed help for this
specific command. For example, syscli help --list nas shows the complete
help for the --list nas command.
(http://
Adding the CLI Directory to the Path