Electric Power Network Specification; Motor Connection Data; Applicable Standards - Salicru CV50-008-4F User Manual

A.3 Electric power network specification
Voltage
Short-circuit capacity
Frequency
A.4 Motor connection data
Motor type
Voltage
Short-circuit protection
Frequency
Frequency resolution
Current
Power limit
Field weakening point
Carrier frequency
A.4.1 EMC compatibility and motor cable length
To comply with the European EMC Directive (standard IEC/EN 61800-3), use the following maximum motor
cable lengths for 4 kHz switching frequency.
All frame sizes
Second environment
(category C3)
Maximum motor cable length is determined by the drive's operational factors.
A.5 Applicable standards
The inverter complies with the following standards:
EN ISO 13849-1: 2008
IEC/EN 60204-1:2006
IEC/EN 62061: 2005
IEC/EN 61800-3:2004
IEC/EN 61800-5-1:2007
IEC/EN 61800-5-2:2007
A.5.1 CE marking
The CE mark is attached to the drive to verify that the drive follows the provisions of the European Low
Voltage (2006/95/EC) and EMC Directives (2004/108/EC).
A.5.2 Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical equipment used within
the European Union. The EMC product standard (EN 61800-3:2004) covers requirements stated for drives.
See section EMC regulations
126 - 144
AC 3PH 380(-15%)~440(+10%)
Maximum allowed prospective short-circuit current at the input power connection
as defined in IEC 60439-1 is 100 kA. The drive is suitable for use in a circuit
capable of delivering not more than 100 kA at the drive maximum rated voltage.
50/60 Hz ± 5%, maximum rate of change 20%/s
Asynchronous inductance motor
0 to U1, 3-phase symmetrical, Umax at the field weakening point
The motor output is short-circuit proof by IEC 61800-5-1
0...400 Hz
0.01 Hz
Refer to Ratings
1.5 · PN
10...400 Hz
4, 8, 12 or 15 kHz
Maximum motor cable length, 4 kHz
30 m without additional output filters
Safety of machinery-safety related parts of control systems - Part 1: general
principles for design
Safety of machinery. Electrical equipment of machines. Part 1: General
requirements.
Safety of machinery – Functional safety of safety-related electrical,
electronic and programmable electronic control systems
Adjustable speed electrical power drives systems. Part 3: EMC
requirements and specific test methods
Adjustable speed electrical power drive systems – Part 5-1: Safety
requirements – Electrical, thermal and energy
Adjustable speed electrical power drive systems – Part 5-2: Safety
requirements. Functional.
Technical Data Appendix A