Salicru CV50-008-4F User Manual page 67

Function
Name
code
FDT2 electrical
P08.34 level detection
value
FDT2 retention
P08.35
detection value
Frequency
P08.36 arrival detection
value
Energy braking
P08.37
enable
Function Parameters
Detailed instruction of parameters
value) the corresponding frequency, the signal is invalid.
Below is the waveform diagram:
Setting range of P08.32: 0.00Hz~P00.03 (the Max. frequency)
Setting range of P08.33: -100.0~100.0% (FDT1 electrical level)
Setting range of P08.34: 0.00 Hz ~P00.03 (the Max. frequency)
Setting range of P08.35: 0.0~100.0% (FDT2 electrical level)
When the output frequency is among the below or above
range of the set frequency, the multi-function digital output
terminal will output the signal of "frequency arrival", see the
diagram below for detailed information:
The setting range:0.00Hz~P00.03
(the Max. frequency)
This parameter is used to control the internal braking unit.
0: Disabled
1: Enabled
Note: Only applied to internal braking unit. After enabling,
the overvoltage stall point will increase by 20V more than
the energy braking point.
Default
Modify
value
50.00 Hz
○
5.0 %
○
0.00 Hz
○
0
○
67 - 144