Salicru CV50-008-4F User Manual page 60

Function
Name
code
Shifting
sequence
P07.03 selection of
QUICK/JOG
commands
STOP/RST
P07.04
stop function
Displayed
P07.05 parameters 1
of running state
Displayed
P07.06 parameters 2
of running state
60 - 144
Detailed instruction of parameters
Note: Press QUICK/JOG to shift between forward rotation
and reverse rotation, the inverter does not record the state
after shifting during powering off. The inverter will run
according to parameter P00.13 during next powering on.
When P07.02=6, set the shifting sequence of running
command channels.
0: Keypad control→terminals control →communication control
1: Keypad control←→terminals control
2: Keypad control←→communication control
3: Terminals control←→communication control
STOP/RST is valid for stop function. STOP/RST is valid in
any state for the fault reset.
0: Only valid for the keypad control
1: Both valid for keypad and terminals control
2: Both valid for keypad and communication control
3: Valid for all control modes
0x0000~0xFFFF
BIT0: running frequency (Hz on)
BIT1: set frequency (Hz flickering)
BIT2: bus voltage (Hz on)
BIT3: output voltage (V on)
BIT4: output current (A on)
BIT5: running rotation speed (rpm on)
BIT6: output power (% on)
BIT7: output torque (% on)
BIT8: PID reference (% flickering)
BIT9: PID feedback value (% on)
BIT10: input terminals state
BIT11: output terminals state
BIT12: torque set value (% on)
BIT13: pulse counter value
BIT14: length value
BIT15: PLC and the current stage in multi-step speed
0x0000~0xFFFF
BIT0: AI1 (V on) Inverters≤15kW can be set by the digital
potentiometer on the keypad and AI1 setting is not available
for the devices ≥18.5kW
BIT1: AI2 (V on)
BIT2: AI3 (V on)
BIT3: HDI frequency
BIT4: motor overload percentage (% on)
BIT5: the inverter overload percentage (% on)
BIT6: ramp frequency given value (Hz on)
BIT7: linear speed
BIT8: AC inlet current (A on)
BIT9: upper limit frequency (Hz on)
Default
Modify
value
0
○
0 ○
0x03FF
○
0x0000
Function Parameters