Table of Contents
Advertisement
9 Communication Protocol
9.1 What this chapter contains
This chapter describes the communication protocol of CV50 inverters.
The CV50 inverters provide RS485 communication interface. It adopts international standard MODBUS
communication protocol to perform master-slave communication. The user can realize centralized control
through PC/PLC, upper control PC, etc. (set the control command, running frequency of the inverter, modify
relevant function codes, monitor and control the operating state and fault information of the inverter and so on)
to adapt specific application requirements.
9.2 Brief instroduction to MODBUS protocol
Modbus protocol is a software protocol and common language which is applied in the electrical controller. With
this protocol, the controller can communicate with other devices via network (the channel of signal
transmission or the physical layer, such as RS485). And with this industrial standard, the controlling devices of
different manufacturers can be connected to an industrial network for the convenient of being monitored.
There are two transmission modes for Modbus protocol: ASCII mode and RTU (Remote Terminal Units) mode.
On one Modbus network, all devices should select same transmission mode and their basic parameters, such
as baud rate, digital bit, check bit, and stopping bit should have no difference.
Modbus network is a controlling network with single-master and multiple slaves, which means that there is
only one device performs as the master and the others are the slaves on one Modbus network. The master
means the device which has active talking right to send message to Modbus network for the controlling and
inquiring to other devices. The slave means the passive device which sends data message to the Modbus
network only after receiving the controlling or inquiring message (command) from the master (response). After
the master sends message, there is a period of time left for the controlled or inquired slaves to response,
which ensure there is only one slave that sends message to the master at a time for the avoidance of single
impacts.
Generally, the user can set PC, PLC, IPC and HMI as the masters to realize central control. Setting certain
device as the master is a promise other than setting by a bottom or a switch or the device has a special
message format. For example, when the upper monitor is running, if the operator clicks sending command
bottom, the upper monitor can send command message actively even it can not receive the message from
other devices. In this case, the upper monitor is the master. And if the designer makes the inverter send the
data only after receiving the command, then the inverter is the slave.
The master can communicate with any single slave or with all slaves. For the single-visiting command, the
slave should feedback a response message; for the broadcasting message from the master, the slave does
not need to feedback the response message.
9.3 Application of the inverter
The MODBUS protocol of the inverter is RTU mode and the physical layer is 2-wire RS485.
9.3.1 2-wire RS485
The interface of 2-wire RS485 works on semiduplex and its data signal applies differential transmission which
is called balance transmission, too. It uses twisted pairs, one of which is defined as A (+) and the other is
defined as B (-). Generally, if the positive electrical level between sending drive A and B is among +2~+6V, it is
logic"1", if the electrical level is among -2V~-6V; it is logic"0".
485+ on the terminal board corresponds to A and 485- to B.
Communication baud rate means the binary bit number in one second. The unit is bit/s (bps). The higher the
baud rate is, the quicker the transmission speed is and the weaker the anti-interference is. If the twisted pairs
of 0.56mm² (24AWG) is applied as the communication cables, the Max. Transmission distance is as below:
108 - 144
Communication Protocol
Advertisement
Table of Contents
