Bandai Namco Time Crisis 5 Operation Manual page 131

■ Replacing the micro switch for the trigger
1 Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2
Remove the gun body (R).
(See 2 in P-124 "(2) Replacing the sensor unit".)
3 Remove the spring and remove the trigger.
4
Disconnect the connector to remove and replace the micro switch for the trigger.
Engage the spring here.
5
To install, perform the procedure in reverse.
6
After replacing the micro switch, be sure to check the operations. (See P-49 "7-7-5 Input/
Output Test of Switches (I/O TEST)", P-47 "(1) SIGHT CALIBRATION (Gun Sight Calibration
Screen)".)
● Be sure to engage the spring with the trigger.
● When installing, be sure to securely lock the connectors.
● When installing, take care not to allow the connectors and harnesses to get caught.
- Must be performed by a technician -
Trigger
Micro switch for the trigger
Connector
Spring
8B. Service
1
2
3
4
5
6
7
8A
8B
9
10
11
131