Bandai Namco Time Crisis 5 Operation Manual page 107

(11) Replacing ohmic sensors
* This section explains the procedure applicable to the monitor tower (L) assembly. Repeat the procedure
for the monitor tower (R) assembly.
● In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
electronic circuits, be sure to turn off the power switch before starting this task.
● PC boards are vulnerable to static electricity. If a person handles a PC board while charged
with static electricity, the parts on the PC board may be damaged. Before handling a PC
board, discharge the static electricity from your body by touching the surface of grounded
metal.
1 Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2
Remove the monitor glass.
(See P-104 "(10) Replacing the monitor glass".)
3 Disconnect the two connectors from the ohmic sensor to be replaced, remove the two
Phillips pan head screws (with flat and spring washers) (M3 x 20) and remove the ohmic
sensor.
WARNING
Ohmic sensor
Capacitor (must face the outside of the monitor)
Connectors
8B. Service
- Must be performed by a technician -
Phillips pan head screws
(with flat and spring washers)
(M3 x 20)
1
2
3
4
5
6
7
8A
8B
9
10
11
107