8B. Service
- Must be performed by a technician -
(3) Replacing the gun harness 2
● In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
126
electronic circuits, be sure to turn off the power switch before starting this task.
1
Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2
Remove the gun body (R).
(See 2 in P-124 "(2) Replacing the sensor unit".)
3
Disconnect the two connectors and replace the gun harness 2.
Gun harness 2
4
To install, perform the procedure in reverse.
5
After replacing the gun harness 2, be sure to check the operations. (See P-49 "7-7-5 Input/
Output Test of Switches (I/O TEST)", P-47 "(1) SIGHT CALIBRATION (Gun Sight Calibration
Screen)".)
● When installing, be sure to securely lock the connectors.
● When installing, take care not to allow the connectors and harnesses to get caught.
WARNING
Connectors