Bandai Namco Time Crisis 5 Operation Manual page 130

8B. Service
- Must be performed by a technician -
(5) Replacing the micro switch
● In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
130
electronic circuits, be sure to turn off the power switch before starting this task.
■ Replacing the micro switch for changing weapons
1
Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2 Remove the gun body (R).
(See 2 in P-124 "(2) Replacing the sensor unit".)
3
Disconnect the two Faston terminals and replace the micro switch.
4
To install, perform the procedure in reverse.
5
After replacing the micro switch, be sure to check the operations. (See P-49 "7-7-5 Input/
Output Test of Switches (I/O TEST)", P-47 "(1) SIGHT CALIBRATION (Gun Sight Calibration
Screen)".)
● Be sure to fully insert the Faston terminals.
● When installing, take care not to allow the harness to get caught.
WARNING
Faston terminal (brown)
Micro switch for changing weapons
Faston terminal (brown/white)