Bandai Namco Time Crisis 5 Operation Manual page 119

(2) Replacing the gun drive PC board
* This section explains the procedure applicable to the gun tower (L) assembly. Repeat the procedure for
the gun tower (R) assembly.
● In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
electronic circuits, be sure to turn off the power switch before starting this task.
● PC boards are vulnerable to static electricity. If a person handles a PC board while charged
with static electricity, the parts on the PC board may be damaged. Before handling a PC
board, discharge the static electricity from your body by touching the surface of grounded
metal.
1
Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2
Remove the 11 Torx bolts (M5 x 12) and remove the gun tower cover (L).
(See 2 in P-117 "(1) Replacing the CPU board".)
3
Disconnect the four connectors, remove the four Phillips pan head screws (with flat and
spring washers) (M3 x 8), and replace the gun drive PC board.
Connectors
4
To install, perform the procedure in reverse.
● When installing, be sure to securely lock the connectors.
● When installing, take care not to allow the connectors and harnesses to get caught.
- Must be performed by a technician -
WARNING
Phillips pan head screws
(with flat and spring washers)
(M3 x 8)
Gun drive PC board
Gun drive PC board
8B. Service
1
2
3
4
5
6
7
8A
8B
9
10
11
119