Delta Electronics DVP15MC11T Operation Manual page 504

When the rotary roller is mounted with multiple knives, the distances between knives should be the same
and the cutting position is at the center of the distance between knives. See the two-knife figure below.
Knife 1
Horizontal line
5. The end curve
It is the rotary-cut curve when the rotary cut function is broken away.
Rotarycut axis
End point
SYNC
area
After the instruction "APF_RotaryCut_Out" is started up, the system will use the curve to make the rotary
cut axis break away from the rotary cut state. Eventually, the knife stops at the end position as shown in
the figure above.
The end position is based on the rotary cut axis. For the single knife, the end position is the entry position
and it is also right above the rotary cut roller.
Cutting position
O
Cutting position
Adjustment area
End of SYNC area
Cutting length
Chapter 12 Troubleshooting
Knife 2
SYNC area
Feed axis
Start of SYNC area
11
11-181