Delta Electronics DVP15MC11T Operation Manual page 502

Rotary cut axis
SYNC
End of SYNC area
In this situation, the feed axis and rotary cut axis in SYNC area and non-SYNC area keep synchronous in
speed. The rotary cut axis does not need to make any adjustment.
3. Long material cutting
When the cutting length is greater than the knife roller circumference, the rotary-cut curve for any cycle
is shown below.
Rotary cut axis
Adjustment area
area
Cutting length equals the
knife roller circumference
C u t t i n g l e n g t h
SYNC
area
Cutting length is greater than the
knife roller circumference
End of SYNC area
Cutting length
SYNC area
Feed axis
Start of SYNC area
Adjustment area
Start of SYNC area
Chapter 12 Troubleshooting
SYNC area
Feed axis
11-179
11