Changing The Parameter Setting Value - Mitsubishi Electric FR-XC-18.5K-PWM Instruction Manual

Operation panel (FR-DU08)
3.1.3
Digital characters and their corresponding
printed equivalents
Digital characters displayed on the operation panel display are as follows.
0
E(e)
Q(q)
3.1.4

Changing the parameter setting value

Changing example Change the setting of Pr.52 PU main monitor selection.
Turning ON the power of the converter
1.
The operation panel is in the monitor mode.
Selecting the parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter
3.
Turn until "
appears.
Changing the setting value
Turn to change the set value to "
displayed alternately.
• Turn
4.
• Press
• Press
• Press
NOTE
• If a parameter write condition is not satisfied, a parameter write error appears on the LCD display. (Refer to
Error indication
POINT POINT
• When Pr.77 Parameter write selection = "2 (initial value)", the parameter setting change is always enabled.
The parameter setting change can be disabled by changing the Pr.77 setting. (Refer to
78
PARAMETERS
1 2 3 4 5
F(f) G(g) H h I(i) J(j) K(k) L(l) M(m) N
R r S(s) T(t) U
" (Pr.52) appears. Press
". Press
to read another parameter.
to show the setting again.
twice to show the next parameter.
twice to return to the monitor mode.
Description
Write disable error
6 7 8 9 A B(b) C
u V v W w X(x) Y(y) Z(z)
Operating procedure
to read the present set value. "
to confirm the selection. "
c D(d)
n O o P(p)
" (initial value)
" and "
page
page 101.)
" are
134.)