Removal and reinstallation of the converter covers
2.1
Removal and reinstallation of the converter
covers
2.1.1
30K converters or lower
Main circuit terminal block cover
• To remove the cover, hold and pull out the upper part of
the cover.
To reinstall the cover, insert the hooks into the slots on the converter and push the cover to snap it into place.
Control circuit terminal block cover
• To remove the cover, loosen the mounting screws of the
cover, and hold and pull out the lower part of the cover.
To reinstall the cover, insert the hooks into the slots on the converter and push the cover to snap it into place.
NOTE
• After installing the cover, check that it is fixed securely in place. Always tighten the mounting screws of the cover.
26
INSTALLATION AND WIRING
• The hooks on the lower end of the cover snap out of
position. The cover is detached from the converter.
Slot
Hook
• The hooks on the upper end of the cover snap out of
position. The cover is detached from the converter.