Parameter Copy; Reading Parameter Settings And Storing Them In Operation Panel; Writing Parameter Settings Stored In Operation Panel To Converter - Mitsubishi Electric FR-XC-18.5K-PWM Instruction Manual

3.7.1

Parameter copy

• Parameter settings in a FR-XC series converter can be copied to another FR-XC series converter.
Reading the parameter settings in the converter and storing them in the
operation panel
1. Connect the operation panel to the source converter.
Selecting the parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn to "
" " appears.
Reading to and storing in the operation panel
Turn to change the set value to "
4.
converter and storing them in the operation panel. (It takes about 30 seconds to read and store all the settings. During
reading, " " blinks.)
End of reading and storing
5.
" " and "
NOTE
• " " appears... Why?
- Parameter read error. Perform operation from Step 3 again.
Writing parameter settings stored in the operation panel to the converter
1. Connect the operation panel to the target converter.
Turning ON the SOF (Converter stop) signal
2.
Turn ON the SOF signal to stop the converter operation.
Selecting the parameter setting mode
3.
Press to choose the parameter setting mode.
Selecting a parameter
4.
Turn to "
" " appears.
Selecting parameter write
5.
Turn to change the set value to "
appears.
Writing to the converter
6.
Press to start writing the parameter settings stored in the operation panel to the converter. (It takes about 60
seconds to write all the settings. During writing, "
End of copying
7.
" " and "
When parameters are written to the target converter, reset the converter before operation by, for example, turning the
8.
power OFF.
NOTE
• " " appears... Why?
- Parameter write error. Perform operation from Step 3 again.
Copying and verifying parameters on the operation panel
Operating procedure
" (parameter copy), and press
". Press
" are displayed alternately after the reading and storing are completed.
Operating procedure
(The parameter number read previously appears.)
" (Parameter copy), and press
", then press
" are displayed alternately after copying ends.
.
to start reading the parameter settings from the
.
.
" blinks.)
PARAMETERS
3
127