Mitsubishi Electric FR-XC-18.5K-PWM Instruction Manual page 55

Control circuit specification
NICHIFU Co., Ltd.
Wire gauge
Blade terminal part
2
(mm )
0.3 to 0.75 BT 0.75-11
(3) Insert each wire into the terminal.
NOTE
• When using stranded wires without a crimp terminal, twist enough to avoid short circuit with neighboring terminals or wires.
• Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause the converter
damage or injury.
• Wire removal
Pull the wire while pushing the open/close button all the way down firmly with a flathead screwdriver.
54
INSTALLATION AND WIRING
Insulation cap
No. part No.
VC 0.75
When using single wire or stranded wires without a crimp terminal, push the open/
close button all the way down with a flathead screwdriver, and insert the wire.
Open/close button
Crimping tool
model No.
NH 69
Open/close button
Flathead
screwdriver
Flathead screwdriver