Parameter Verification - Mitsubishi Electric FR-XC-18.5K-PWM Instruction Manual

Copying and verifying parameters on the operation panel
3.7.2

Parameter verification

• Whether the parameter settings of converters are the same or not can be checked.
Copy the parameter settings in the verification source converter to the operation panel according to the procedure on
1.
page 127.
2. Detach the operation panel from the source converter and attach it to the verification target converter.
Turning ON the power of the converter
3.
The operation panel is in the monitor mode.
Selecting the parameter setting mode
4.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting a parameter
5.
Turn to "
" " appears.
Parameter verification
Turn to change the setting value to "
Press . Verification of the parameter settings copied to the operation panel and the parameter settings in the
6.
verification target converter is started. (It takes about 60 seconds to verify all the settings. During verification,
" " blinks.)
● If there are different parameters, the different parameter number and "
● To continue verification, press
7.
" " and "
NOTE
• " " blinks... Why?
- Check the parameter setting of the source converter against the setting of the target converter. To continue verification,
press
128
PARAMETERS
Operating procedure
" (Parameter copy), and press
.
" are displayed alternately after verification ends.
.
.
" (Parameter copy verification).
" are displayed alternately.