Download  Print this page

Operation Panel (Fr-Du08) - Mitsubishi Electric FR-XC-18.5K-PWM Instruction Manual

Fr-xc series multifunction regeneration converter
Hide thumbs

Advertisement

Table of Contents

Operation panel (FR-DU08)

3.1
Operation panel (FR-DU08)
3.1.1
Components of the operation panel
Installing the inverter operation panel (FR-DU08) on the multifunction regeneration converter allows to set the converter
parameters and monitor the converter status.
No.
Component
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
76
PARAMETERS
(j)
(k)
(l)
(m)
Name
Not available for the FR-XC(-PWM) converter.
MON: ON when the operation panel is in the monitor mode. Quickly blinks twice
Operation panel mode
intermittently while the converter protective function is activated.
LED indicator
PRM: ON when the operation panel is in the parameter setting mode.
Not available for the FR-XC(-PWM) converter.
Not available for the FR-XC(-PWM) converter.
Shows a numeric value, a parameter number, etc.
Monitor (5-digit LED)
(The monitor item can be changed according to the Pr.52 setting.)
Not available for the FR-XC(-PWM) converter.
FWD key: Its LED is ON during power driving.
REV key: Its LED is ON during regenerative driving.
The LEDs are OFF when the converter stops its operation due to power supply failure or
FWD key, REV key
when a fault occurs.
The LEDs blink when the converter stops its operation due to a cause except the above-
mentioned cause.
Used to stop operation commands.
STOP/RESET key
Used to reset the converter when the protective function is activated.
Turn the setting dial to select a parameter or change the parameter setting.
Setting dial
Press the setting dial to display a fault history number in the fault history mode.
Switches the operation panel to a different mode.
MODE key
Holding this key for 2 seconds locks the operation of the operation panel.
Used to confirm each selection.
Pressing this key during the converter
operation changes the monitor item to be
SET key
displayed.
(The monitor item can be changed according to the Pr.52 setting.)
Goes back to the previous display.
ESC key
Holding down this key changes the mode of operation panel back to the monitor mode.
PU/EXT key
Cancels the PU stop warning.
(a)
(b)
(c)
Description
(d)
(e)
(f)
(g)
(h)
(i)
Initial setting in the monitor mode
Input current
Input voltage
Bus voltage

Advertisement

Table of Contents
loading

  Related Manuals for Mitsubishi Electric FR-XC-18.5K-PWM