Setup Alarm Messages - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Set-Up Using Web Pages (Cont.)

Setup Alarm Messages

This setup page is used to configure
switched alarm signals.
1. Click Setup Alarm Messages to access
the Alarm Message Setup page
(Figure 62).
NOTE:
Before setting up signals, fill out Master Alarm
Signal Input Data table on page 138.
2. Click on the Alarm Input link for the
signal to set up.
3. The Signal Setup - Step 1 page will be
displayed (Figure 63).
4. Select the gas type from the drop-down
menu then click Next.
NOTE:
If a custom gas type is required, select Custom
from the Gas Type drop-down menu.
80
6-847718-00 Rev. B00
NOTE:
These settings can be transferred from one
TotalAlert 2 master or combo alarms to another
master or combo alarm. Refer to Transfer Setup
on page 98.
Figure 62: Alarm Message Setup