Remote Sensor Back Box - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Rough-In
Alarm Panel Back Box (Cont.)
Loosen screws to
adjust back box depth
(same each side)
Figure 17: Mounting Bracket Adjustment
24
6-847718-00 Rev. B00

Remote Sensor Back Box

Alarm panels ordered with remote
sensors are provided with separate metal
boxes for each sensor. Mount each
sensor box as follows:
1. Remove sensor rough-in from
mounting box (Figure 18).
2. Using four mounting holes provided,
attach box to a wall or other structural
support (fasteners by others).
3. Reinstall sensor rough-in.
Four holes in back of box are
provided for surface mounting
Rear conduit knockouts
(either side) are recommended
for sensor wiring
Figure 18: Remote Sensor Back Box