Labeling - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Finish

Labeling

Multiplexer Module/LED Module
Label each LED using the provided gas
service identification labels.
Multiplexer module LEDs are numbered 1
through 5 from top to bottom.
LED module LEDs are numbered 6
through 10 from top to bottom.
1. Apply gas identification label to insert.
2. Slide insert with label into pocket in
front of multiplexer or led module
(Figure 35).
Annunciator Module (Area Alarms)
Label annunciator module using provided
panel location label.
1. Mark location on panel location label.
2. Slide location label into pocket in front
of annunciator module (Figure 36).
Figure 35: Multiplexer Module Labeling
Figure 36: Annunciator Module Location Label
Align gas ID label
with line on insert
43
6-847718-00 Rev. B00