Enroll Devices - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Set-Up Using Web Pages (Cont.)

Enroll Devices

Each TotalAlert 2 alarm panel keeps a list
of up to 75 other devices on the medical
gas network.
1. Click on Enroll Devices to access the
Enroll Devices Setup page (Figure 59).
2. Click on an unused Device # link to
enroll a new device.
3. Enter the device IP address and Device
Serial Number then click Submit
(Figure 60).
4. The Enroll/Delete Device Complete
page will be displayed (Figure 61).
5. Click Return to Enroll Devices to return
the the Enroll Device Setup page.
78
6-847718-00 Rev. B00
NOTE:
The factory default settings will cause all devices
on the same subnet to be automatically
discovered. Enroll Devices is only necessary if
the alarm network is spread across multiple
subnets.
Figure 59: Enroll Device Setup
NOTE:
Device # links are disabled for automatically
enrolled devices.
NOTE:
Fixed IP addresses should be used for manually
enrolled devices. If a manually enrolled device's
IP address changed, the entry in the device list is
NOT automatically updated.