BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions page 63

Set-Up Procedures
Annunciator Module (Cont.)
Only unused LEDs and LEDs with the
same gas type are available.
8. Return to step 5 for remaining inputs.
9. After setting up Input B32 the alarm
panel will return to monitoring mode.
10. To return to monitoring mode without
setting up every signal, press SETUP
button again.
Reset Users and IP Configuration
1. While holding the SETUP button, press
and release the RESET button.
2. Continue to hold the SETUP button for
5 seconds.
3. The parameters listed in Table 2 will be
set to factory defaults.
Reset Factory Defaults
CAUTION:
This procedure will revert annunciator module set-
tings to factory defaults. There is no way to
recover previously programmed settings after
resetting factory defaults.
1. While holding the SETUP button, press
and release the RESET button.
2. Continue to hold the SETUP button for
10 seconds.
3. The parameters listed in Tables 2 and 3
will be set to factory defaults.
Setting
User 1 Name
User 2 Name
User 3 Name
User 1 Password
User 2 Password
User 3 Password
IP address mode
Subnet mask
Default fixed IP
address
Default fixed subnet
mask
Default fixed gateway192.168.1.1
Automatic discovery Enabled
Date/Time format
SMTP server
address
Table 2. Reset Users and IP Config.
Setting
Facility
Contact
Location
SMTP server name
Email address 1
Email address 2
Email address 3
Email address 4
Email address 5
All area locations
Peer network device list
Event log
All signal gas types
All signal LEDs
All signal locations
All signal messages
All custom gas types
Table 3. Reset Factory Defaults
Factory default
new
[Blank]
[Blank]
new
[Blank]
[Blank]
Try DHCP, then try
fixed IP address
255.255.255.0
192.168.1.100
255.255.255.0
24 hours
0.0.0.0 (unused)
Factory default
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
[Blank]
Cleared (including
manually entered
devices)
Cleared
Unused
0 (unassigned)
[Blank]
Input XXX
"Custom"
6-847718-00 Rev. B00
61