Area Alarms - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Alarm Configurations (Cont.)

Area Alarms

Area alarm panels include the following modular
components:
• Annunciator module
• 4 or 8 digital display, multi-signal or blank
modules
• Sensors for all digital display modules
(except 6-TA2AN series)
Area alarm panels may consist of any
combination of digital display modules, multi-
signal modules or blank modules.
If alarm panel is configured with digital display
modules, pressure/vacuum sensors will be
included for connection to pressure / vacuum
pipeline (except 6-TA2AN series).
Sensors may be located inside alarm panel
back box (local sensors) or outside alarm panel
back box (remote sensors).
Local sensors must be connected to pressure /
vacuum pipelines via copper tubing (Figure 5).
Remote sensor may be mounted near pressure
/ vacuum pipeline and then wired to alarm panel
(Figure 6).
Two alarm panel sizes support either 4 or 8
alarm modules.
Figure 5: Local Sensors
12
6-847718-00 Rev. B00
Copper tubes connect to
pressure/vacuum
pipelines
Sensor modules are
mounted inside alarm
panel box
Copper tubes connect to
pressure/vacuum pipelines
Figure 6: Remote Sensors
Model Number Scheme:
Position within alarm panel
(Figures 7 and 8)
1 2 3 4 5 6 7 8
6-TA2A _ - _ _ _ _ _ _ _ _
L = Local Sensors
R = Remote Sensors
N = No Sensors
O OXYGEN
D OXYGEN - 100 PSI
X NITROUS OXIDE
A MEDICAL AIR
F MEDICAL AIR - 100 PSI
5 AIR (ISO)
7 LABORATORY AIR
2 O2-CO2
4 O2-He
C CARBON DIOXIDE
G CARBON DIOXIDE - 100 PSI
1 CO2-O2
3 He-O2
H HELIUM
V VACUUM
6 VACUUM (ISO)
8 LABORATORY VAC
W WAGD
N NITROGEN
9 INSTRUMENT AIR
J ARGON
M MULTI-SIGNAL MODULE
R MULTI-SIGNAL MODULE W/ RELAYS
B BLANK
Sensors have separate
mounting boxes for
mounting near
pressure/vacuum
pipeline and then must
be wired to alarm panel
Designates type of alarm
panel component from table