Master Alarms; Area Alarms - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Master Alarms

1. Install alarm panel back box (Page 23).
2. Pull wire (Page 27).
3. Power supply wiring (Page 30).
4. Breakout board input wiring (Page 32).
5. Relay board wiring (Page 33).
6. Front panel installation (Page 40).
7. Ethernet wiring (Page 37).
8. General fault/Aux Relay wiring (if
required) (Page 36).
9. Building automation system wiring (if
required) (Page 37).
10. Labeling (Page 43).

Area Alarms

1. Install alarm panel back box (Page 23).
2. Install remote sensor back box (if
required) (Page 24).
3. Pipeline connections (Page 25).
4. Pull wire (Page 27).
5. Power supply wiring (Page 30).
6. Front panel installation (Page 40).
7. Remote sensor wiring (if required)
(Page 31).
8. Sensor installation (Local: Page 41,
Remote: Page 42).
9. Ethernet wiring (Page 37).
10. Digital display module master/slave
wiring (if required) (Page 35).
11. Digital display module high/low relay
wiring (if required) (Page 36).
12. Multi-signal module input wiring (if
required) (Page 34).
13. Multi-signal module relay output wiring
(if required) (Page 35).
14. General fault/Aux Relay wiring (if
required) (Page 36).
15. Labeling (Page 43).
21
6-847718-00 Rev. B00