Wiring Schematic 2: Sensor Module To Digital Display Module - BeaconMedaes TotalAlert 2 Installation, Operation And Maintenance Instructions

Wiring Schematic 2: Sensor Module to Digital Display Module

LOCAL SENSOR
*
Sensor pigtail
Pin 6 - black (-)
Digital Display Module
REMOTE SENSOR
Sensor pigtail
(provided)
Field wiring
(by others)
Pin 6 (-)
Digital Display Module
NOTE:
Field wiring cable shields must be grounded at
only one end, inside alarm panel back box. Refer
to page 39 for details.
2-pin polarized connector
Pin 5 - red (+)
20 wire
ribbon cable
to adjacent
module
(inside alarm panel back box)
2-pin polarized connector
Wire nuts
Pin 5 (+)
20 wire
ribbon cable
to adjacent
module
*
NOTE:
Sensor pigtails for local sensors are factory con-
nected to digital display module.
GAS ID
Local Sensor
Remote sensor mounting box
(remote from alarm panel)
47
6-847718-00 Rev. B00