Replacing The Balance Bar - Porsche 911 GT3 Cup 2018 Techical Manual

3.9.2 Replacing the balance bar

 Remove the R-clips, spacers, circlips and clevises from the balance bar
 Remove the balance bar
DANGER
 Screw the new balance bar fully into the trunnion in the housing
 Push a new retaining ring on the balance bar
NOTE
 Set the balance bar back to center (see chapter "balance bar setup" 3.8.1)
 The installation is carried out in reverse order
NOTE
Version: 4/20/2018
Retaining rings and snap rings
Snap ring or retaining ring drops out
Failure of brake system
Loss of control over the vehicle
 Always replace the snap rings or retaining
rings with new ones after removal.
Do not over stress the retaining ring, if it deforms it
will not perform correctly
Following each use of the vehicle, the needle roller
bearings must be coated with tenacious grease to
protect them against dirt.
Chassis
911 GT3 Cup (991 II)
MY 2018
219