Oil Pump Assembly - Porsche 911 GT3 Cup 2018 Techical Manual

2.9.9 Oil pump assembly

Grease O rings (1) and insert them in the oil pump housing
Remove the drive gear
Put on the oil pump and four nuts and then tighten with 4 Nm (3 ft-lb) using a crisscross
pattern. Check whether the shaft can be spun smoothly at that.
Final tightening of the oil pump with 10 Nm (7.4 ft-lb)
Put on the oil pump gearwheel; ensure that the feather key is inserted in the shaft here
Information
Insert locking ring (1) 10x1 (Figure 2.9.9.2)
Version: 4/20/2018
The label the gearwheel must point toward the oil
pump because the oil pump gearwheel is not fully
covered with idler gear 1 st gear otherwise.
Powertrain
2.9.9.1
2.9.9.2
911 GT3 Cup (991 II)
MY 2018
127