Porsche 911 GT3 Cup 2018 Techical Manual page 263

Bodywork
4.15.1.21
4.15.1.24
4.15.1.25
911 GT3 Cup (991 II)
262
Saw template for left side
The three threaded bores (1) are used as a fixing point.
4.15.1.22
The inner reinforcement plate (2) must not be damaged when cutting.
4.15.1.23
Clamp a plate (arrow) between the support and reinforcement plate to protect the
reinforcement plate (2). Transfer the saw line (1 Figure 4.15.1.24) at the front end of
the template onto the support from the top to the bottom and align it centrally to the
rivet bore.
The saw cut for the right support frame is shown.
The distance from the rear end to the saw line is 504 mm (19.84 inch) (measured
from the inside of the support).
MY 2018
The outer saw cut only goes through the outer panel.
Information
Version: 4/20/2018