Table of Contents
Advertisement
Maintenance
911 GT3 Cup (991 II)
396
Brake fluid
WARNING
It is recommended venting the system after each practice and changing the
fluid after each race
Use the brake fluid from Performance Friction Brakes, Racing Brake Fluid-
325° (DOT 4)
Three persons are required.
Fill quantity: approx. 1,000 ml (1.06 qt)
Proceed as follows for changing the brake fluid:
1.
Remove the brake fluid from the brake fluid reservoir of the two master cylinders
using a syringe
2.
Pour in new brake fluid
Flushing/Bleeding:
3.
Build up pressure with the brake pedal
4.
Open the front axle and rear axle brake bleeder valves simultaneously and close
them again
5.
Only release the brake pedal when the bleeder valves have been closed. Build up
new pressure with the brake pedal.
6.
Repeat the process and make sure that there is enough brake fluid in the reservoir.
7.
Perform flushing operation on both valves of a caliper (order of no importance)
MY 2018
Corrosive fluids
Danger of chemical burns
Wear personal protective equipment.
•
Ensure good ventilation.
•
Avoid contact with corrosive fluid.
•
If you do come into contact, wash off immediately
•
with plenty of warm water and contact a doctor if
necessary.
Version: 4/20/2018
Advertisement
Table of Contents
