Wiring Harness - Porsche 911 GT3 Cup 2018 Techical Manual

Electrical system
The wiring harness is separated as follows:
 Engine
Vehicle cable harness

 Front axle wheel carrier
 Rear axle wheel carrier
 Front section
 Fuel tank
Starter cable B+

 Steering
Item Connection designation
1 connector optionlights right
2 t ambient sensor
3 transponder
4 windshield heater 2
5 connector optionlights left
6 option abs
8 windshield heater 1
9 option light ID
911 GT3 Cup (991 II)
358

Wiring harness

For the 911 GT3 Cup (991 II), a wiring harness that runs along the center tunnel from
the front to the back has been specially developed for racing use. The cable ends of
the main wiring harness are labeled and color-coded; a white marking indicates a plug
connection that is mated as standard, a blue marking indicates an optional plug
connection.
Pin assignment options cable harness
Plug type on the wiring
harness
DT 04-4 P
DTM 06-2 S
DTM 06-2 S
B01G01
DT 04-4 P
DTM 06-12 SA
B01G01
DTM 06-2 S
MY 2018
If a plug connection is required for video systems or
Information
data loggers, only the CAN Option/Sensor may be
used.
Further information is available from 'Technical Racing
Support'.
Corr. mating connector
DT 06-4 S
DTM 04-2 P
DTM 04-2 P
DT 06-4 S
DTM 04-12 PA
DTM 04-2 P
Pin assignment/max. current
1. +12V high beam/15A
2. GND high beam
3. +12V foglight/4A
4. GND foglight
1. +5V
2. sig
1. +12V
2. GND
GND
1. +12V high beam/15A
2. GND high beam
3. +12V foglight/4A
4. GND foglight
1. +12V Ct. 30/3A
2. +12V Ct. 15/0,5A
3. sig 1
4. sig 2
5. CAN 1 high
6. CAN 1 low
7. GND
8. n.c.
9. n.c.
10. n.c.
11. n.c.
12. n.c.
1. +12V
2. GND
1. GND
2. +12V
Version: 4/20/2018