Premounting Shift Drum - Porsche 911 GT3 Cup 2018 Techical Manual

2.9.8 Premounting shift drum

Powertrain
2.9.8.1
Put adjusting disk (6) Basic (1.4 mm) on the shift drum (7)
Insert the grooved ball bearing (5)
Put on the bushing (4) (observe installation position)
Insert the gearshift shaft spacing washer (3)
Insert the grooved ball bearing (2)
Screw on the nut (1) (flattened side in the direction of the grooved ball bearing (2)) and
2.9.8.2
tighten with 60 Nm (44.3 ft-lb) with tool no. 21 (Figure 2.9.8.2) Use Loctite 243.
Moisten the bushing (4) with oil
Insert the shift drum (7)
The bushing (4) and locking sleeve are not screwed onto the gearbox housing until
chapter 2.9.11 Locking sleeve.
911 GT3 Cup (991 II)
Version: 4/20/2018
126
MY 2018