Porsche 911 GT3 Cup 2018 Techical Manual page 112

Pressing in gear housing bearings and bushings
Caution
After the studs are inserted, the gear housing has to set in an oven for approx. 40
minutes at 130°C (266 F). The heat is also required for the next work step
(inserting the bearings).
All bearings must be inserted quickly before the housing has cooled off. To ensure the
proper seat of the bearings, all bearings must be tapped with an appropriate tool after
the housing has cooled off.
Labels of outer and inner bearing rings generally point in the direction of the pressing
tools during the pressing in process!
Gearbox bleeding bushing
Adhesive:
Press in up to the limit
Drive shaft cylinder roll bearing (2)
Dimensions:
Tool:
Version: 4/20/2018
Hot components
Danger of burns
Wear personal protective equipment.

Loctite 638
34x62x17
No. 1
Powertrain
2.9.2.7
911 GT3 Cup (991 II)
MY 2018
111